User`s manual

Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 24
Q. Top-of-form won't stay set; it drifts on longer documents.
A. In the embosser's menu, turn on perf skip and set lines per page to 17.27E
BUT on your computer, translate your document to only 25 lines per Braille
page. The embosser sequence is:
OL Takes the embosser off-line
0.1E Enter Menu 1 (as an example)
11.1E Turn perf skip on
17.27E Put 27 lines of Braille on a page
1.1E Make these settings current
Remember to change your translator settings to 25 lines per page and try the
document again.
Q. I get the first line of a document but the rest is blank. How could that
happen?
A. Usually your Braille translator regulates the length of your lines and pages.
But some programs and some devices, such as Notetakers, allow you to set
line and page length to zero, because the embosser can also take care of
these format considerations by itself. If you receive one line of a document
followed by a lot of blank space, the problem may be that there are no line
or page endings in your document. To have the embosser do the formatting,
you need to turn on the right features in the menus. From the embosser's
keypad, enter the current menu and:
11.1E Turn on perf skip
10.1E Turn on word wrap
22.1E Turn on hot zone
1.1E Reset embosser and use these settings
These parameters are already factory-set in menu 4. However, this menu is
set up for serial transfers where the host device provides absolutely no
formatting, and this may or may not correspond exactly to your situation. Try
menu 4 first without changes and if necessary, experiment a little (you can
always reset the embosser) until you have the format you want.
The problem could also be the absence of line-feeds in your file. Some
devices and programs provide the option of ending each line with a carriage
return but no line-feed. The embosser needs a line-feed paired with each
carriage return. If line-feed characters are in your document but the
embosser is not acting on them, check the manual of your translator if you
are using one, or your Notetaker if this is your host device. There should be