User`s manual

Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 23
port where the data is being routed. Many systems have more than one serial
port. Also, take a careful look at the serial port settings on your computer,
because if any of these are different than you expect, this could be the
source of trouble. But if everything checks out as it should and you are
unable to get data with the cable we supplied, call us; one way or another,
we will help you puzzle out the problem.
Q. I get characters from the embosser all right, but they are mostly the
letter x and they don't seem to have many spaces. Could the Braille
translator be messing up my document?
A. This sounds more like a baud rate error. The embosser and your computer
are probably set to different baud rates. Change the one which is easier to
adjust. Since the baud rate or speed of data transfer cannot be set or
changed in a parallel interface, the most likely cure for "garbage" characters
in a parallel printout is to try a different parallel interface cable.
Q. Could it be that this Braille embosser doesn't understand grade 2
Braille? The words have no contractions, and the punctuation doesn't look
right.
A. The embosser prints exactly what the computer sends. In order to produce
well formatted grade 2 Braille, your files must pass through a translator
program, which creates an entirely new file in Braille. If you have translation
software on your computer, there may be some reason why it is being
bypassed. If you do not have Braille translation software installed on your
computer, call us at ETC for information about prices and features. (We have
worked with most of the translators currently on the market.)
Q. What causes the embosser to skip a blank page after each full page?
A. The lines per page in your document most likely exceeded the lines per
page setting on the embosser. The embosser automatically sends out a form-
feed if the lines per page exceeds the value set with 17.NNE in all menus.
You may also want to turn off a feature called "perf skip," which keeps the
pages neatly divided if your software doesn't add page breaks, in your
embosser's current menu. Assuming that menu 1 has control of your
embosser, the following sequence turns perf skip off:
OL Takes the embosser off-line
0.1E Enter Menu 1
11.0E Turn perf skip off
1.1E Make this change current now and reset embosser