User`s manual

Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 20
Example: You want to maximize the "reverb" to see what it sounds like. Enter
these commands on the embosser's keypad:
OL Takes the embosser off-line
0.0E Enter the Service Menu
57E Select Reverb as the setting to change
9E Set Reverb to the maximum
1E Exit the Service Menu
Back to normal? Repeat all commands above EXCEPT replace 9E with 0E.
SINGLE SHEET MODE (Optional)
Single Sheet Mode is an option that may have been installed at the factory so
that your embosser will emboss Braille on loose sheets of paper or other
lightweight material. With Single Sheet Mode, you copy a document into the
embosser's memory, then Braille the document by feeding paper through the
embosser one sheet at a time. Single sheet mode makes it possible for you to
use paper that does not have the tractor edges of standard Braille paper.
IMPORTANT! In Single Sheet Mode, the maximum number of lines that can
fit on a page is 22. Format translated documents for 22 or
fewer lines per page for best results. All menu changes must
be finished before starting to print in Single Sheet Mode.
Entering menus while off-line exits the Single Sheet Mode, as does turning
the machine off.
Single Sheet Mode Basic Steps
Place the first sheet of paper on the tractor rollers. Turn on the embosser.
Enter the following on the embosser's keypad:
OL Takes the embosser off-line
0.1E Enter Menu 1 (or any menu you happen to be using, as
Single Sheet Mode works with any menu)
17.22E Set the number of lines per page to 22
11.1E Turn on perf skip
1.1E Exit menu and reset embosser