User`s manual

Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 18
OL stops printing temporarily in Multi-Copy. Printing continues when OL is
pressed again.
V stops printing and moves the paper out from under the platen, so the
Braille which was just printed can be read. Press V again to move the paper
back and resume printing.
OL, then LF, FF or 0.0E to enter the Service Menu while off-line exits
Multi-Copy. The current copy will not be completed but the buffer remains
unchanged. You can continue Multi-Copy by going back on-line and entering
the 4.NNE sequence.
ET SPEAKS (Optional)
ET Speaks and Your Embosser
As you've noticed if your embosser is equipped with ET Speaks, your
embosser automatically voices all the keypad entries you make and all its
own status messages with no intervention necessary from you. However,
while using ET Speaks as the voice of your embosser, two keys can help you
control the speech when the embosser is ON-LINE.
The LF key makes ET Speaks repeat its last phrase
The FF key makes ET Speaks "shut up" in mid-phrase
Turn Speech Off and Change Voices In The Embosser Menus
For embossers equipped with ET Speaks, all sixteen menus have the following
additional settings to modify the speech:
25.0E Turns the speech OFF
25.1E Turns the speech ON (the default)
25.2E Speech ON with spoken escape sequences
25.3E Speech ON but without counting the copies as they emboss
in Multi-Copy
36.NE Chooses a different voice by substituting a number from 0
to 5 for the "N". 0 is the default (i.e., 36.0E)
Example: You use an IBM-compatible computer and have your embosser
connected to one of the computer’s parallel ports. You want to turn the
speech off. To do this, turn on the embosser. Then, on the embosser's
keypad, enter: