User`s manual

Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 17
Run a single test copy of your file first, to be sure margins, paper size, page
breaks, etc., are correct. Whatever menu is active when you start Multi-Copy
is the one that continues to control the embosser once you start making
multiple copies, so make any necessary adjustments to the menu before
starting Multi-Copy.
When your file is ready for multiple copies, remain on-line, and enter the
following on the embosser's keypad:
3.0E Turn on Multi-Copy
Go back to your computer and send or copy your file to the embosser. After
the file is copied into the embosser's memory, go back to the embosser's
keypad and, staying on-line, enter the following:
3.1E Tell the embosser that the file is completely copied
If no data was received from the computer, an error tone will sound, warning
you that the buffer is still empty. If the file is too large (over 18 pages) for
the embosser, the "Buffer Full" tone will sound and the embosser will also
begin printing the text that has exceeded the buffer. This allows you to see
where in your file the overflow occurred so you will know where to split your
document. Tell the embosser how many copies to make. Enter the following
on the embosser's keypad:
4.NNE "NN" stands for "any number up through 99"
For example, if you want 10 copies, you'd enter 4.10E. If you want 99 copies,
you'd enter 4.99E. If your embosser is equipped with ET Speaks, it will count
off copies as they emboss so you can monitor how the job is progressing. If
you'd rather squelch this feature, you can turn it off within the menu you're
using with 25.3E.
Other Controls in Multi-Copy
3.2E Stops printing at the end of the current copy
3.3E Cancels Multi-Copy and clears the buffer
3.4E Suspends Multi-Copy at the top of the next sheet of paper
If you don't turn off the power or reset the machine, you can send another
short document and resume printing where you left off.
3.5E Resumes Multi-Copy after the 3.4E sequence. Check that
the paper is at top-of-form prior to entering this command