User`s manual

Thomas, ET, Juliet Classic, Juliet Pro, Juliet Pro 60 10
Setting Top-of-Form
Top-of-form tells the embosser where the paper starts and where to begin the
Braille. You need to tell the embosser to reset top-of-form whenever you
change paper or adjust the top margin, which we call the top-of-form offset.
The distance from the edge of the paper to where the Braille begins is
adjustable in 0.1 inch increments by using the top-of-form offset setting
(Parameter 30.NNE) found in each of the machine's 16 menus. For 25 lines
embossed on 11 inch paper we generally recommend a top-of-form offset of 3 or
0.3 inches. The default setting is 0. To change it to 3 enter the following:
OL Takes the embosser off-line
0.1E Enter menu number 1. If you are using a different menu,
substitute the alternate menu number for the 1 in the
sequence
30.3E This will set a top-of-form offset value of 3 or 0.3 inches.
This setting will remain until you change it, even after power
is turned off
1.1E This will install the change and reset the embosser
If you have paper loaded in the embosser, check to be sure the tractors are
securely holding the paper and that the paper can flow smoothly into the
embosser with no obstructions. Turn on the embosser and listen for the "Romeo
& Juliet" tune that signifies the embosser is ready to run.
To set top-of-form, enter the following on the embosser's keypad:
OL Takes the embosser off-line
2E Set top-of-form
An automatic sensor inside the embosser seeks the edge of the paper, so the
paper should begin to move back and forth until the sensor fixes the location of
the paper's edge in the embosser's memory. After setting top-of-form, the
embosser returns on-line automatically, signified by the two-note on-line tune.
IMPORTANT! The embosser's sensor must find the paper's edge to set
top-of-form, which makes pages break in the right places. When
you reset top-of-form in the middle of a printing session, remove
any finished pages before issuing the 2E command. Every time
you install a new batch of paper or clear a paper jam, remember
to reset top-of-form with the OL, 2E sequence.
The embosser will remember the top-of-form setting when you move the paper
with LF, FF or V.