User`s guide

Page
37
of
48
Ver
2.
3
Toll Bypass + Call Forward
If you enable both toll bypass and call forward, then the call forward number will only be
dialed if you do not enter your pin code within10seconds.
Skype Voicemail
WithSkylink Proactive, the attached telephone handset can be used to check for, and
listen to your Skype voicemail.
When you have a new Skype voicemail that you have not listened to, you will hear an
intermittent beep in the VoIP dialtone.
If you have no new voicemail (i.e. either no voicemail or voicemail that you have already
listened to), the standard VoIP dial tone will be heard.
You can access your voice mail only when there is no call in progress.
In order to access your voicemail:
1.Pick up theattached telephonehandset
2.Press ‘##’ to get VoIP dial tone
3.If anewSkypevoice message exists the VoIP dial tone will have an intermittent
beep
4.Press ‘*’ to access voicemail mode
5.Once in voice mail mode the firstmessage is played automatically
6.At the end of each message a trailing ‘beep” is played
7.At the end of the last messages a trailing ‘beep-beep-beep’ is played
8.During the playing of current message and within 5 seconds following the end of
message the you can press the 1, 2, 3, 9 in order to perform the following actions:
User Action Key
Repeat current message1
Delete current message, move to next2
Keep current message, move to next3
Delete all messages9
9.If you don’t enter any valid keywithin 5 sec after message hasended, the system
will behave as if you pressed ‘3’
To exit voicemail mode press ‘##” or place the attached telephone in the handset (i.e. on
hook). Alternatively, pressing ‘#1’ will also exit voicemail mode. In either case, the
currently playing message will be stopped.