E-SMART THERMOSTAT W960 Thermostat and Controller Operation
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
ISEDC Warning This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d' Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
1. Thermostat Operation PIR Sensor Home Screen (It shows the current room temperature value) Low Battery LED [UP] Touch Button [Power/MENU] Touch Button [DOWN] Touch Button [FAN Speeds] Touch Button Turn On the Screen Touch any key on the screen (e.g. , , , ) to turn on the screen. Confirm Selected Option Press button. Fan Setting Press button to enter the fan setting.
Power OFF the System Power ON the System 1. In the home screen, press . MODE AUTO 2. Press to select the options of “MODE OFF”. Wait for 2 seconds, the option will be selected. MODE OFF 3. A word “OFF” will show on the screen, which means the system is powered off. OFF to select other options of 1. Press “MODE”. Wait for 2 seconds, the option will be selected. 2. If the system is powered on, it will show the home screen. Main Menu (MODE, FAN, TEMP.
Restore Profile Setting Press and hold and button for 10 seconds. The prompt Restore profile setting will appear on the thermostat. Press any key or 3 seconds timeout, then the thermostat will be reset to the profile setting you have configured with the EC Tool. Override Temperature Setpoint Press and hold setpoint.
Engneering Mode Press and hold , , , for 10s to access the engineering mode. The menu options of engineering mode are as below: System Setting Press or Press to confirm the selected option. Tour Exit to select different options. Menu options of “System Setting”: System Setting System Configuration Registration About This Unit Reset to Factory Default Menu options of “Registration”: Register Device Deregister Device Tour Tour It is the demo for you to try out and have fun.
2. Controller Operation LED Indicator [PAIR] Button Pair the Controller with Thermostat Hold [PAIR] button on your controller for 5 seconds (but less than 10 seconds), then release the button to start searching an available thermostat. Stop Pairing the Controller with Thermostat Hold [PAIR] button for 10 seconds and release to start unpairing.
Controller LED Indicator Dual Color LED Condition Annotation Press and hold [PAIR] for 5s (less than 10s), the controller indicator will turn to flash green, and when you release the button, will enter Zigbee pairing mode. Flash green Start Zigbee pairing During the process of Start Zigbee pairing (with the controller indictor is flash green), if user want to stop the pairing process, can press and hold [PAIR] for 5s. Solid green Flash yellow Paired. Normal operation.
support@vtechhotelphones.
Specifications are subject to change without notice. Copyright © 2022 VTech Communications, Inc. All rights reserved. 8/18. W960_Operation_QSG_V3_2022.08.
