User Guide

EN - 12
Installation
SIP Next Gen Cordless 1-line Hotel
Telephone - NG-S3411
SIP Next Gen Cordless 1-line Wi-Fi
Enabled Hotel Telephone - NG-S3411W
Telephone base installation
The telephone comes ready for desktop use.
1. Install the telephone base as shown below.
• NOTE: Power adapter is not required for
Power over Ethernet (PoE).
2. When the telephone base has been initially
installed, make sure the power adapter is
securely plugged into an outlet not controlled
by a wall switch, and the Ethernet cable is
plugged into the network wall jack.
• The battery is fully charged after 11
hours of continuous charging. For best
performance, keep the cordless handset
in the telephone base when not in use.
3. Press on the telephone base. Listen for a
dial tone, and then press again to hang
up.
Note
• The dial tone will not be played if the SIP
account used by this telephone cannot be
registered.
• The power adapter is sold separately.
• Use only the power adapter described in
"Technical specifications" on page 36.
CAUTIONS
Use only the supplied Ethernet cables. The
supplied Ethernet cables are not designed for
use in any other IT devices. Misusing them on
your other IT devices shall be prohibited. To
order a replacement, call 1-888-907-2007.
Installation option - install base stand
for desktop
To mount the telephone base on the base
stand
1. Align the grooves of the base stand with the
telephone base.
2. Slide the base stand up to secure it.