User Guide

4
GETTING STARTED
BATTERY INSTALLATION
NOTE: For best performance, remove all factory-installed batteries
from the VTech
®
Drill & Learn Toolbox
TM
and use new
alkaline batteries.
1. Make sure the unit is OFF.
2. Locate the battery cover on the bottom of
the ELECTRONIC PROJECT TRAY and
open it with a screwdriver.
3. Install 2 new “AA” size batteries following
the diagram inside the battery box. (New
alkaline batteries are recommended for
maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinre.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
GETTING STARTED