User`s manual

6
BATTERY INSTALLATION – ELECTRONIC PIT STOP
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the right
side of the electronic pit stop. Use a
a screwdriver to loosen the screw.
3. Install 2 new “AAA” (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable(Ni-Cd,Ni-MH),ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries fromthetoybefore charging(if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Battery Notice