Operating instructions

7
DC 9V
MODEL: 2625
VTECH TELECOMMUNICATIONS LTD.
MANUFACTURED IN CHINA
CORDLESS TELEPHONE
VTECH TELECOMMUNICATIONS LTD.
DC 9V 400mA
CLASS 2 POWER SOURCE ONLY
COMPLIES WITH 47 CFR PART 68
REGISTRATION NO.: US: EW7WI01B80-531200
RINGER EQUIVALENCE: 0.1B USOC JACK: RJ11C
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE;
AND 2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED,INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION PRIVACY OF COMMUNICATIONS
MAY NOT BE ENSURED WHEN USING THIS PHONE
TEL. LINE
HAC
FCC ID: EW780-5312-00
VTech Customer Service 1-800-595-9511
www.vtechphones.com
To AC outlet
CORDLESS TELEPHONE
VTECH TELECOMMUNICATIONS LTD.
DC 9V 150mA
CLASS 2 POWER SOURCE ONLY
To AC outlet
Connecting Power to Base Unit/Handset Charger
1. Plug the AC power adapter into an electrical outlet, and the DC connector into the
bottom of the Base Unit.
2. Choose the location for your Handset Charger, and plug its power supply into an
electrical outlet.
Setup
Getting Started
Installation and Charge of Battery Cells in Handset
Follow the steps below:
1. Place the new battery cells in the
Handset with the positive and
negative poles aligned in the battery
compartment.
2. Replace the battery cover by sliding it
upwards
3. If the new battery cells are not already
charged, place the Handset in its
Charger or Base Unit, and allow it to
charge for 10-12 hours. After initial
charge, a maintenance charge of 8
hours should be sufficient.
WARNING: Alkaline batteries must NOT be used in your ev 2625 cordless
telephone. Use only the batteries that came with your phone, or contact
our Customer Support Center (contact information on page 2) to order
additional batteries.