User Guide

EN - 12
Installation
SIP 1-Line Hidden Base with Cordless
Color Handset and Charger -
CTM-S2116
SIP 1-Line Hidden Base - CTM-S2110
Base station installation
This section assumes that your network
infrastructure is established and that your
IP PBX phone service has been ordered
and configured for your location. For more
information about IP PBX configuration, please
refer to the SIP Phone Configuration Guide.
You can power the base station using a
compatible VTech power adapter or using
Power over Ethernet (PoE Class 2) from your
network. If you are not using PoE, install the
base station near a power outlet not controlled
by a wall switch. The base station can be
placed on a flat surface or mounted on a wall
in a vertical or horizontal orientation.
To install the base station:
Plug one end of the Ethernet cable into the
Ethernet port on the rear of the base station
(marked by NET), and plug the other end
of the cable into your network router or switch.
If the base station is not using power from a
PoE-capable network router or switch:
Connect the supplied power adapter to the
base station power jack.
Plug the power adapter into an electrical outlet
that is not controlled by a wall switch.
IMPORTANT INFORMATION
1. Use only a compatible VTech power
adapter. To order a replacement power
adapter, call
1 [phone].
2. The power adapter is intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or
cabinet outlet.