Quick Start Guide

To mount the base station on a wall:

1. Install two mounting screws on the wall. Choose screws with heads larger than 5 mm

(3/16 inch) in diameter (1 cm / 3/8 inch diameter maximum). The screw centers should

be 5 cm (1 15/16 inches) apart vertically or horizontally.

2. Tighten screws until only 3 mm (1/8 inch) of the screws are exposed.

3. Attach the mounting plate to the top of the base station. Insert the tab into the slot and

then push the plate in at the bottom of the base station until the mounting plate

clicks into place.

4. Check to make sure the plate is secure at top and bottom. It should be ﬂush with the

base station body.

Insert tab into slot.

DRAFT