User's Manual
Table Of Contents
- Introduction
- Getting Started
- Conference phone operation
- Phone Features
- Configuring the Phone
- Wireless Mic Registration
- WebUI
- Appendix
- Troubleshooting
- Precautions for users of implanted cardiac pacemakers
- About wireless mics
- Maintenance
- FCC, ACTA and IC regulations
- The RBRC® seal
- California Energy Commission battery charging testing instructions
- For C-ETL compliance only
- Mesures de sécurité importantes
- Limited warranty
- Technical specifications
Troubleshooting
57
I have accidentally set my LCD language to Spanish or French, and I don’t
know how to change it back to English.
• When the base unit is not in use or on a call, press MENU → 3 → 1 → 1 → 1.
Common cure for electronic equipment.
• If the telephone is not responding normally, put the wireless mics onto the
charging cradles. If it does not respond, try the following (in the order listed):
1. Disconnect the power to the base unit.
2. Remove the battery from the wireless mics.
3. Wait a few minutes before connecting power to the base unit.
4. Install the battery again and place the wireless mics onto the charging cradles.
5. Wait for the wireless mic to synchronize with the base unit. Allow up to one
minute for this to take place.