User's Manual
Table Of Contents
- Introduction
- Getting Started
- Conference phone operation
- Phone Features
- Configuring the Phone
- Wireless Mic Registration
- WebUI
- Appendix
- Troubleshooting
- Precautions for users of implanted cardiac pacemakers
- About wireless mics
- Maintenance
- FCC, ACTA and IC regulations
- The RBRC® seal
- California Energy Commission battery charging testing instructions
- For C-ETL compliance only
- Mesures de sécurité importantes
- Limited warranty
- Technical specifications
9
Status indicators overview
Status indicator on the base unit
Green (two seconds) • Power up.
Green (steady) • On a call.
Red (steady) • System is muted during a call.
Green (slow ash) • Call on hold.
Green (fast ash) • Incoming call.
Yellow (ash) • Line unregistered or Network Down.
Bluetooth Status indicators
CELL 1 LED (BLUE) CELL 2/HEADSET LED (BLUE)
Steady Bluetooth Device 1 is connected. Bluetooth Device 2 or headset is
connected.
Fast ash Incoming call on Device 1. Incoming call on Device 2.
Slow ash Device 1 is on hold. Device 2 is on hold.
LEDs ash
alternately
Base is in discovery mode. Base is in discovery mode.
Status indicator on the wireless mic
Orange (two seconds) • Power up.
Orange • Charging on the cradle except during registration.
Orange (ashing) • Mic battery is low.
Red/Green alternating • Wireless mic is registering to the base.
Green • On a call.
Green (fast ash) • Incoming call.
Red • System is muted during a call.
Red (slow ash) • Mic is out of range or not registered or off cradle during
paging.
Off • Mic is in idle mode or without a battery.
Getting Started