User's Manual

Getting started
5
Telephone base and charger installation
Install the telephone base and charger as shown below.
IMPORTANT INFORMATION
Use only the power adapter(s) supplied with this product. To order a replacement power
adapter, visit our website at www.telephones.att.com or call
1 [phone]. In Canada, dial 1 [phone].
For more detailed instructions, refer to the online Complete user’s manual at
www.telephones.att.com/manuals.
The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
•
•
Charger installation
Telephone base installation
Plug the power adapter into a power outlet not
controlled by a wall switch.
Raise the antenna.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
Route the power adapter
cord through this slot.
Plug the small end of the telephone base power
adapter into the power adapter jack on the back
of the telephone base.
Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by
a wall switch.
Plug one end of the
telephone line cord into a
telephone jack or a DSL filter.
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
Route the telephone line
cord through this slot.