User's Manual

Telephone operation
15
Options while on calls
Chain dialing
Use this feature to initiate a dialing sequence from the numbers in the
directory, caller ID history or redial memory while you are on a call.
To access the directory or caller ID log while on a call:
Press MENU/
SELECT.
Press q
CID or pDIR to scroll to >Directory or >Caller ID log, then press
MENU/SELECT.
Press q
CID or pDIR to scroll to the desired number.
Press
MENU/SELECT to dial the number shown.
To access the redial list while on a call:
Press REDIAL/
PAUSE to show the most recently dialed number.
Press q
CID or pDIR to scroll to the desired number, or press REDIAL/PAUSE
repeatedly to show the last 10 recently dialed numbers. Press MENU/SELECT
to dial the number shown.
Blind transfer
While on an outside call, you can transfer it to a specific handset or any
handset.
To transfer an outside call directly without notifying the desired handset:
1. During the call, press MENU/
SELECT.
2. Press
MENU/SELECT to choose >Transfer.
If you have a two-handset system, the outside call is put on hold and
your handset screen shows Transferring call... The other handset rings
and its screen shows Transfer from other handset.
If you have more than two handsets, your screen shows TRANSFER TO:
Press q
CID or pDIR to scroll to the desired handset and press
MENU/SELECT. The outside call is put on hold and your handset screen
shows Transferring call... or Transferring call to all...
3.
To answer the call on the destination handset, press, press PHONE/FLASH,
/SPEA�ERSPEA�ER, or any dialing key (0-9, TONE , or #). The original handset
shows Call transferred and goes to idle mode.
1.
2.
3.
4.
1.
2.
•
•