User's Manual
Table Of Contents
- Getting started
- Parts checklist
- Quick reference guide - handset
- Telephone base and charger installation
- Battery installation and charging
- Installation options
- Handset settings
- Handset operation
- Intercom
- Call transfer using intercom
- Push-to-talk (PTT)
- Directory
- Speed dial
- Caller ID
- Answering system settings
- About the answering system
- Message playback
- Recording and playing memos
- Remote access
- Adding and registering handsets/headsets
- Deregistering handsets
- Troubleshooting
- Maintenance
- Important safety information
- FCC Part 68 and ACTA
- FCC Part 15
- Limited warranty
- Technical specifications
- Index
6
Getting started
Battery installation and charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged
after 10 hours of continuous charging. See the table in the Technical
specifications section on page 47 for battery operating times.
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger
and
(flashing).
Battery has no or
very little charge. The
handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
(flashing).
Battery has enough
charge to be used for a
short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged, place it in the
telephone base or charger when not in use.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert the
supplied battery with
the label THIS SIDE UP
facing up as indicated.
Step 2
Align the cover flat against
the battery compartment,
then slide it upwards until
it clicks into place.
Step 3
Charge the handset by placing it face forward in the
telephone base or charger. The CHARGE light on the
top of the handset is on during charging.
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or replacement
battery (model BT183342/BT283342). To order, visit our
website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial
1 (866) 288-4268. For more detailed instructions,
refer to the online Complete user’s manual at
www.telephones.att.com/manuals.
If you do not use the handset for a long time, disconnect
and remove the battery toprevent possible leakage.
•
•
CHARGE light
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine