User's Manual

88
Answering system
Answering system settings
In the answering system setup menu, you can change the settings
for call screening, number of rings, remote access code, message
alert tone and recording time.
Call screening
The call screening feature lets you listen at the telephone
base to a caller leaving a message. While monitoring an
incoming message, you can answer the call by pressing
HOME/FLASH or /SPEAKER on the handset, or pressing
HOME on the telephone base.
To turn call screening on or off:
Using a handset or telephone base:
Press MENU in idle mode to enter the main
menu.
Use
CID or DIR on the handset or CID or DIR
on the telephone base to scroll to Answering sys,
then
press SELECT .
Use
CID or DIR on the handset, or CID or
DIR on the telephone base to scroll to Ans sys
setup, then
press SELECT twice to select Call screening.
Press CID or DIR on the handset, or CID or DIR on the
telephone base to choose between On and Off, then press SET
to save. You hear a confirmation tone.
NOTE: For more information on call screening, see page 94.
1.
2.
3.
4.
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
On
Off
BACK SET
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
On
Off
BACK SET