User's Manual

Bluetooth

Bluetooth setup

Device list and connection

Up to 4 devices can be paired to the telephone base. All paired devices are

shown on the device list. To use a paired device, it must be in an active slot

(CELL 1 or CELL 2) on the device list and connected. Two Bluetooth cell

phones can be on a call at a time. While you are on a cell line call, you can

also use a Bluetooth headset to make or answer a home line call.

Once you have paired a device with the telephone base, you do not need

to repeat the pairing procedure again unless you delete the device from the

device list.

NOTE:

When connecting a Bluetooth device to the device list, all connected devices will be

temporarily disconnected until the procedure is complete. It may take up to 2 minutes to

reconnect.

Review the device list

Press MENU on the telephone base in idle mode.

Press CID or DIR to highlight Bluetooth, then press SELECT .

Press CID or DIR to highlight Device list, then press SELECT .

Connect/disconnect an active device

While in the device list menu, you may connect or

disconnect your active device.

Press MENU on the telephone base in idle mode.

Press CID or DIR to highlight Bluetooth, then

press SELECT.

Press CID or DIR to highlight Device list, then press

SELECT .

Press CID or DIR to highlight a device, then

press OPTION .

Press CID or DIR to highlight Connect/Disconnect

(whichever is applicable), then press SELECT . The

telephone base displays Device connected/Device

disconnected. You hear a confirmation tone.

NOTE: When your active device is connected, you are prompted to

select Disconnect. When your active device is disconnected, you are

prompted to select Connect.