User's Manual

17
Bluetooth
Bluetooth setup
The screen displays Adding Headset A to device list... when the base is
connecting to your headset.
When a device is successfully connected, the telephone base displays
Headset A is added and connected to base and the corresponding status
icon ( 1 or 2). You hear a confirmation tone. The corresponding light on
the telephone base (CELL 1 or CELL 2) turns on.
If you have trouble pairing your headset, it may not be compatible
with your TL96273/TL96373/TL96473/TL96323. Check the Bluetooth
compatibility list at www.telephones.att.com.
NOTES:
The pairing process may take up to one minute. If the pairing process fails, try again.
When a connected headset is charging, it may disconnect from the telephone base and
the corresponding light on the telephone base (CELL 1 or CELL 2) turns off. For some
headset models, you may need to turn on the headset and reconnect it to the telephone
base again.
Auto connection
When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the device.
When the device moves out of range, it is disconnected. Your device might
make a connect or disconnect sound.
A connected device could also be disconnected by:
Turning off the Bluetooth device.
Turning off the Bluetooth feature of the device.
Disconnecting through the telephone base Device list. If you disconnect
through the Device list, the telephone base will not attempt to reconnect until
your device is moved out of range and then moves back in range again.
Bluetooth connection from idle mode
When you have active devices that are not connected,
CONNECT appears
on the telephone base in idle mode. Press CONNECT to start connecting an
active device. When there are two active devices, the screen will prompt you to
choose one before connection.
9.
10.
•
•
•
•
•