User's Manual

ManualsBrandsVTech Telecommunications ManualsElectronics1.9GHz Digital Modulation Cordless Phone - Base Unit

Getting started

IMPORTANT INFORMATION:

Use only the supplied rechargeable battery or

replacement battery (model BT166342). To order, visit

our website at

www.telephones.att.com or call

1 (800) 222-3111. In Canada, dial

1 (866) 288-4268. For more detailed instructions,

refer to the online Complete user’s manual at

www.telephones.att.com/manuals.

If you do not use the handset for a long time, disconnect

and remove the battery to prevent possible leakage.

•

Step 3

Charge the handset by placing it face forward in the

telephone base or charger. The CHARGE light on the

top of the handset is on during charging.

CHARGE light

Battery installation and charging

Once you have installed the battery, the screen indicates the battery status

(see table below). For best performance, keep the handset in the telephone

base or charger when not in use. The battery is fully charged after 11 hours

of continuous charging. See the table in the Technical specifications section

on page 122 for battery operating times.

Battery indicators Battery status Action

The screen is blank or

shows Place in charger

and flashes.

The battery has no or

very little charge. The

handset cannot be used.

Charge without interruption (at least 30

minutes).

The screen shows

Low battery and

flashes.

Battery has enough

charge to be used for a

short time.

Charge without interruption (at least 30

minutes).

The screen shows

HANDSET X.

Battery is charged. To keep the battery charged, place it in the

telephone base or charger when not in use.

Step 1

Plug the battery connector

securely into the socket

inside the handset battery

compartment, matching the

color-coded label. Insert the

supplied battery with the

label THIS SIDE UP facing

up as indicated.

Step 2

Align the cover flat

against the battery

compartment, then slide

it upwards until it clicks

into place.

THIS SIDE UP / CE CÔTÉ VERS LE HAUT

Battery Pack / Bloc-piles :

BT183342/BT283342 (2.4V 400mAh Ni-MH)

WARNING / AVERTISSEMENT :

DO NOT BURN OR PUNCTURE BATTERIES.

NE PAS INCINÉRER OU PERCER LES PILES.

Made in China / Fabriqué en chine BY1142