User's Manual

Getting started

Telephone base installation

If you subscribe to high-speed Internet service (digital subscriber line - DSL)

through your telephone line, you must install a DSL filter between the

telephone line cord and the telephone wall jack. The filter prevents noise and

caller ID problems caused by DSL interference. Please contact your DSL service

provider for more information about DSL filters.

Follow the steps below to install the telephone.

NOTE: The telephone base comes ready for tabletop use. If you want to mount your

telephone on a wall, refer to Installation options on pages 10-11 for details.

Plug the other end

of the telephone

line cord into the

telephone jack on

the bottom of the

telephone base.

Telephone line cord

Route the cords

through the guides.

Plug the small

end of the larger

power adapter into

the power jack on

the bottom of the

telephone base.

Plug the large end of the

larger power adapter into

an electrical outlet not

controlled by a wall switch.

Plug one end of the

telephone line cord

into a telephone

wall jack.

Raise the

antenna.

A DSL filter (not

included) is required

if you have DSL

high-speed Internet

service.

The DSL filter must

be plugged into the

telephone wall jack.