User's Manual

5
Getting started
Install the telephone base and charger as shown below.
The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, refer to Wall mount installation on page 8 for details.
Telephone base and charger installation
IMPORTANT INFORMATION:
Use only the power adapters provided with this
product. To obtain a replacement, visit our website
at
www.telephones.att.com or call
1 [phone]. In Canada, dial
1 [phone].
Plug the large end
of the smaller power
adapter into an
electrical outlet not
controlled by a
wall switch.
Ensure the small end
of the smaller power
adapter is plugged into
the power jack on the
back of the charger.
Route the cord through
the slot.
Telephone line cord
A DSL filter (not included)
is required if you have
DSL high-speed Internet
service.
Plug the small end
of the larger power
adapter into the power
jack on the back of the
telephone base.
Plug the large end
of the larger power
adapter into an
electrical outlet not
controlled by a wall
switch.
Plug the other end
of the telephone line
cord into the TEL. LINE
jack on the back of the
telephone base.
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
Route the cords
through the slot.