User's Manual

26
Bluetooth
Bluetooth setup
Replace an active device
If you already have two active devices on the device list and you want to
activate a different device, you must deactivate one of the two active device.
NOTE: When adding, removing, or replacing a Bluetooth device on the active devices list, all
connected devices are temporarily disconnected until the procedure is complete. It may take
up to two minutes to reconnect.
To replace an active device:
Press MENU on the handset when it is not in use.
Press
CID or DIR to highlight Bluetooth, then
press SELECT.
Press
CID or DIR to highlight Device list, then
press SELECT.
Press CID or DIR to highlight the device you want to
activate, without a prefix D1: or D2:, then press OPTION.
Press CID or DIR to highlight Connect, then press
SELECT. The screen displays Only 2 devices can be
ready for connection and then a list of devices for
deactivation.
Press
CID or DIR to highlight the device to be
deactivated, then press NEXT. The screen displays Cell
Phone A is deactivated and you hear a confirmation
tone. The screen then displays Connecting Cell Phone B
to the base...
Depending on your cell phone settings, you may
need to press a key on your cell phone to confirm
the connection. When the new device is successfully
activated and connected, the screen displays
Device connected. You hear a confirmation tone.
Bluetooth connection from idle mode
When you have active devices that are not connected,
CONNECT appears
on the
telephone base in idle mode. Press CONNECT to start connecting an
active device. When there are two active devices, the screen will prompt you
to choose one before connection.
1.
2.
3.
4.
5.
6.
7.
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
DEVICE LIST
D1:Headset A
D2:Cell Phone A
Cell Phone B
BACK OPTION
DEACTIVATE
D1:Headset A
D2:Cell Phone A
BACK SELECT
Connecting
Cell Phone B
to the base...
DEVICE LIST
D1:Cell Phone B
D2:Cell Phone A
Headset A
BACK OPTION