User's Manual

Bluetooth

Bluetooth setup

Device list and connection

Up to four devices can be paired to the telephone base. All paired devices

are shown on the device list. To use a paired device, it must be in an active

slot (DEVICE 1 or DEVICE 2) on the device list and connected. Only one

Bluetooth cell phone or a headset can be on a call at a time.

Once you have paired a device with the telephone base, you do not need

to repeat the pairing procedure again unless you delete the device from the

device list.

NOTE:

When connecting a Bluetooth device to the device list, all connected devices

will be temporarily disconnected until the procedure is complete. It may take up to two

minutes to reconnect.

Review the active device list

You can change the name of a paired device on the paired devices list.

Press MENU on the telephone base in idle mode.

Press

CID or DIR to highlight Bluetooth, then press SELECT.

Press

CID or DIR to highlight Device list, then press SELECT.

Connect/disconnect an active device

While in the active devices menu, you may connect or disconnect your active

device.

Press MENU on the telephone base in idle mode.

Press

CID or DIR to highlight Bluetooth, then press

SELECT.

Press CID or DIR to highlight Device list, then

press SELECT.

Press

CID or DIR to highlight a device when

necessary, then press OPTION.

Press

CID or DIR to highlight

Connect/Disconnect

(whichever is applicable)

, then press SELECT.

The handset displays Device connected/Device

disconnected. You hear a confirmation tone.

NOTE: When your active device is connected, you are prompted to

select Disconnect. When your active device is disconnected, you are

prompted to select Connect.