User's Manual

117
Answering system
Answering system settings
In the answering system setup menu, you can change the settings for call
screening, number of rings, remote access code, message alert tone and
recording time.
Call screening
The call screening feature lets you listen at the telephone base to a caller
leaving a message. While monitoring an incoming message, you can answer
the call by pressing
HOME/FLASH or /SPEAKER on the handset, or
pressing
HOME on the telephone base.
To change the settings:
Using a cordless handset:
Press MENU on the handset in idle mode to enter the
main menu.
Use
CID or DIR to scroll to Answering sys, then
press SELECT.
Use
CID or DIR to scroll to Ans sys setup, then
press SELECT twice to select Call screening.
Press CID or DIR to choose between On and Off, then
press SET to save. You hear a confirmation tone.
Using the telephone base:
Press MENU on the telephone base in idle mode to enter the main menu.
Use
CID or DIR to scroll to Answering sys, then
press SELECT.
Use CID or DIR to scroll to Ans sys setup, then
press SELECT twice to select Call screening.
Press CID or DIR to choose between On and Off,
then press SET to save. You hear a confirmation tone.
NOTE: For more information on call screening, see page 123.
1.
2.
3.
4.
1.
2.
3.
4.
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
3On
Off
BACK SET
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
3OnHandset
Off
BACK SET