User's Manual

6
Getting started
Battery installation and charging
Battery charging
Once you have installed the battery, the screen indicates
the battery status (see the table below). If necessary,
place the handset in the telephone base or charger to
charge the battery. For best performance, keep the handset
in the telephone base or charger when not in use. The
battery is fully charged after 10 hours of continuous
charging. See Technical specifications on page 74 for battery
operating times.
If the screen is blank, you need to charge the handset without interruption
for at least 30 minutes to give the handset enough charge to use the
telephone for a short time. The screen shows LOW BATTERY until you
have charged the battery without interruption for at least 30 minutes. The
following table summarizes the battery charge indicators and actions to take.
NOTES:
If you are on a call in low battery mode, you hear 4 short beeps every 50 seconds.
If no battery is installed in the handset when you place it in the telephone base or charger,
the CHARGE light does not turn on and the screen shows NO BATTERY. Follow the
instructions in Battery installation on page 5 to install the battery.
•
•
10:30
PM
11/20
HANDSET 1
16 MISSED CALLS
Battery status icon
After you install your telephone or power returns following
a power outage, the handset will prompt you to set the
date and time (see page 13). To skip setting the date and
time, press
OFF/CANCEL.
SET DATE
--/--/--
Battery indicators Battery status Action
The screen is blank or shows
PLACE IN CHARGER.
Battery has no or very little
charge. The handset cannot
be used.
Charge without interruption (at
least 30 minutes).
The screen shows
LOW BATTERY and
flashes.
Battery has enough charge
to be used for a short time.
Charge without interruption (at
least 30 minutes).
The screen shows HANDSET X
and the battery icon shows
, or .
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
Getting started
7
Wall mount installation
The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall mount bracket to connect with
a standard dual-stud telephone wall mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronics retailers. Professional assistance may be required to install the
mounting plate.
Tabletop to wall mount installation
To change the telephone base from tabletop installation to wall mount
installation, make sure you first unplug the power adapter from the electrical
outlet and unplug the telephone line cord from the telephone wall jack.
Plug one end of the telephone line cord into the TEL. LINE jack on the
bottom of the telephone base. Plug the small end of the base power
adapter into the power jack on the bottom of the telephone wall jack.
Position the telephone base as shown below. Insert the extended tabs
of the wall mount bracket (marked B) into the slots on the back of the
telephone base. Push the telephone base down until it clicks securely
in place.
Route the telephone line cord through the wall mount bracket hole. Route
the power cord out of the bottom of the telephone.
1.
2.
3.
Slots for wall mount
bracket installation
A DSL filter (not included) is
required if you have DSL
high-speed Internet service.
Wall mount
bracket