User's Manual

Appendix

Add and register a headset

You can add a new headset (IS6100, purchased separately) to your telephone

system. The headset must be registered with the telephone base before use.

You may need to charge the headset before registering it to the telephone base.

For more details on headset charging, see page 5.

To register a headset:

Place the non-registered headset in the telephone base and allow it to charge

for at least 15 minutes before beginning registration. Remove the headset

from the telephone base. The light on the headset flashes slowly and

alternately in red and blue.

On the telephone base of the cordless telephone, press and hold

/FIND HANDSET for about four seconds until the red IN USE light turns on.

Immediately place the headset in the telephone base. It takes about 60

seconds to complete the registration. The red IN USE light on the telephone

base turns off. The light on the headset turns red when it is registered but

not fully charged, or turns blue if it is registered and fully charged.

If the registration process is successful, you hear a dial tone when you press

on the headset. If the registration fails, you hear “Not registered” through the

headset earpiece when you press on the headset. The light on the headset

flashes slowly and alternately in red and blue. To reset the headset, remove

it from the telephone base and then place it back into its charger. Try the

registration process again.

You cannot register a headset if any other system handset or headset is in use.

The headset must be deregistered before registering it to another telephone

system.

•