User's Manual

80
Handset settings
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can
change the code to any number from 00 to 99.
To change the remote code:
Press MENU on the handset in idle mode to enter the
main menu.
Use
CID or DIR to scroll to Answering sys, then
press SELECT.
Use CID or DIR to scroll to Ans sys setup, then
press SELECT.
Press
CID or DIR to scroll to Remote code, then
press SELECT.
Use the dialing keys (0-9) to enter a two-digit number
from 00-99, then press SET to save. You hear a confirmation tone.
Press
MUTE/DELETE to erase a digit.
Press and hold
MUTE/DELETE to erase all digits.
Press
CID to move the cursor to the right or DIR to the left.
Message alert tone
When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you of new messages. The tone stops when all new
messages have been reviewed. The default message alert setting is off.
To change the setting:
Press MENU on the handset in idle mode to enter the main menu.
Use
CID or DIR to scroll to Answering sys, then
press SELECT.
Use
CID or DIR to scroll to Ans sys setup, then
press SELECT.
Press
CID or DIR to scroll to Msg alert tone, then
press SELECT.
Press CID or DIR to choose between On and
Off, then press SET to save your setting. You hear a
confirmation tone.
NOTE: You cannot set the message alert tone when another handset or the telephone
base is accessing the answering system.
1.
2.
3.
4.
5.
•
•
•
1.
2.
3.
4.
5.
ANS SYS SETUP
Call screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SET
ANS SYS SETUP
# of rings
Remote code
Msg alret tone
BACK SELECT
MSG ALERT TONE
3On
Off
BACK SET