User's Manual

57
Multiple handset use
Push-to-talk (PTT)
PTT to all handsets
When you have two to four registered handsets, PTT supports one-to-all
calls (one-to-four maximum). However, when you have six or more registered
handsets, PTT supports a maximum of one-to-three calls. The first four
registered handsets will be able to use this feature. Other handsets can only
use PTT for one-to-one calls.
To begin a PTT-to-all call:
Press and hold PUSH TO TALK when the handset is not in use.
If you have three or more handsets, press PUSH TO TALK when the
handset is not in use. Press TONE
and #, or press CID or DIR to
highlight Group then press
SELECT or PUSH TO TALK.
Your handset displays Connecting to group... for a few seconds. When
the connection is made, both your and the destination handsets display
Press and hold [PTT] to talk and beep once.
Press and hold PUSH TO TALK on your handset. A chirp indicates your
microphone is on. Speak towards the handset. Your voice is broadcast to
the destination handset. While you are speaking, the handset displays PTT
To handset X (X represents the destination handset).
Release PUSH TO TALK after speaking. All handsets beep once again.
After the handsets beep, you can press and hold PUSH TO TALK to
continue speaking or the destination handsets can respond (see
Answer a PTT call on page 58)
Press OFF/CANCEL or END to end the PTT call. The handset displays
Push to talk Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call.
NOTES: After PUSH TO TALK is released, the PTT call remains open for a short time. If no
one presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.
1.
•
•
2.
3.
4.