User's Manual

29
Handset settings
Telephone settings
Set date and time
The answering system announces the day and time of each message prior to
playing it. If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. If you do not want to set the date
and time automatically with caller ID information, turn this feature off (see
Use caller ID to automatically set date and time on page 34). However, the
year must be correct so that the day of the week can be calculated from the
caller ID information. Before using the answering system, set the date and
time as follows.
After handset registration or a power failure,
the handset
will prompt you to set the date and time
(see page 9).
To set the date and time:
Press MENU on the handset in idle mode to enter the
main menu.
Press
CID or DIR to highlight Set date/time, then
press SELECT.
Use the dialing keys (0-9) to enter the month. For
example, enter 02 for February.
-OR-
Press
CID or DIR to choose the month and then
press SET.
Repeat Step 3 to set the date and year, and then
press SET.
Repeat Step 3 to set the hour and minute, and then
press SET.
Press
CID or DIR to choose AM or PM, or press 2 for AM or 7 for PM.
Then press SET
to save. You hear a confirmation tone.
NOTE: If the date and time is not set when a message is recorded, the system announces,
“Time and day not set,” before each message plays.
1.
2.
3.
1.
2.
3.
Intercom
Bluetooth
Ringers
Set date/time
BACK SELECT
SET DATE
09/30/10
MM/DD/YY
BACK SET
SET TIME
05:41PM
BACK SET