User's Manual

Getting started

Installation options

Your telephone base is ready for tabletop use. If you want to mountIf you want to mount

your telephone on a wall, use the provided wall mount bracket to attach

to a standard dual-stud telephone wall mounting plate. If you do not

have this mounting plate, you can purchase one from many hardware or

consumer electronics retailers. You may need a professional to install the

mounting plate.

Tabletop to wall mount installation

Plug one end of the telephone line cord into the TEL LINE jack on the

bottom of the telephone base. Plug the small end of the telephone base

power adapter into the POWER jack on the bottom of the telephone base.

Position the lower portion grooves on the telephone base to the lower

portion tabs (marked B) on the wall mount bracket. Make sure the upper

portion grooves of the telephone base are above the upper portion tabs

(marked A) on the wall mount bracket. Push the telephone base down

until it clicks securely in place.

Route the telephone line cord (or DSL filter) through the wall mount

bracket hole and plug it into the telephone wall jack. Route the power

cord out of the bottom of the telephone and plug it into an electrical

outlet not controlled by a wall switch.

Align the holes on the bracket with the standard wall plate and slide the

bracket down until it locks securely. Bundle the telephone line cord and

power adapter cord neatly with twist ties.