User's Manual

Appendix

Expand your telephone system

The handsets provided with your telephone system are already registered.

Additional handsets registered to the telephone system are assigned

in sequential order. For instance, if you already have HANDSET 1 and

HANDSET 2, the new registered handset is assigned HANDSET 3. This

telephone system accommodates up to 12 handsets.

Add and register a handset (optional)

You can add new handsets (TL90071, purchased separately) to your

telephone system, but each handset must be registered with the telephone

base before use. When first purchased, each expansion handset shows

Put handset on BASE to register

after a battery is installed.

Each handset

should be charged without interruption for at least 30 minutes before

registering to the telephone base. For more details on battery charging, see

the table on page 10.

To register a handset:

Make sure the handset shows Put handset on

BASE to register. Place the handset you wish to

The handset displays Registering handset...

on the handset and the red IN USE light on

the telephone base turns on. It takes about 90

seconds to complete the registration process.

The handset displays HANDSET X Registered

(X represents the registered handset number).

The IN USE light turns off and the handset

beeps when registration completes.

If registration fails, it will automatically restart.

If it fails after three trials, the handset displays

Registration failed for a few seconds, then

Put handset on BASE to register. To reset the

handset, remove it from the telephone base. When

the handset displays Put handset on BASE to register,

try the registration process again.

NOTE: You cannot register a handset if any other system handset

is in use.