User's Manual

6
Getting started
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com or call
1 [phone]. In Canada, dial 1 [phone].
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Telephone base installation
Install the telephone base as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see page 10 for details.
Plug the small end
of the AC power
adapter into the
power jack on
the bottom of the
telephone base.
•
Plug one end of
the telephone
line cord into the
telephone jack on
the bottom of the
telephone base.
•
Place the cords into
the channels.
•
Plug the other
end of the
telephone line
cord into a
telephone jack or
a DSL filter.
•
Plug the other
end of the coiled
handset cord
into the jack at
the left of the
telephone base.
•
Raise the
antenna.
•
Plug the large end of
the AC power adapter
into a power outlet
not controlled by a
wall switch.
•
If you have DSL high
speed Internet service,
a DSL filter (not
included) is required.