User's Manual

31
Registration and de-registration
Adding and registering headset
To register a headset to the headset base:
Make sure the battery is properly installed in the
headset (see page 10). The ON/OFF light will
flash twice every five seconds to indicate the
headset is not registered.
Place the headset in the headset base and allow
it to charge for at least five minutes before
beginning registration.
Remove the headset from the base. Press and
hold the PAIR button until the MUTE light on the
headset base turns on (about four seconds) and
release the button.
Place the headset back in the headset base to
register the headset.
Registration may take up to 10 seconds to
complete. The MUTE light on the headset base
will turn off The headset ON/OFF light will be
blue on the first headset registered. The headset
ON/OFF light will turn orange on the second
headset registered. To verify registration was
successful, press the headset ON/OFF button
and check for a dial tone.
If the registration is not successful, the
ON/OFF light on the headset will flash twice
every five seconds. To reset the headset, remove
the headset from headset base and try the
registration process again.
1.
2.
3.
4.