User's Manual

Answering system
76
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be heard over
the telephone base speaker when they are being recorded. If you turn call
screening on, you hear the incoming message. While monitoring an incoming
message, you can answer the call by pressing
PHONE/FLASH or /SPEAKER
on the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
SELECT to
enter the main menu.
2. Press T
CID or SDIR to scroll to >Answering sys, then
press
MENU/SELECT.
3. Press T
CID or SDIR to scroll to >Ans sys setup, then
press
MENU/SELECT.
4. Press
MENU/SELECT to select >Call screening.
5. Press T
CID or SDIR to choose >On or >Off.
6. Press
MENU/SELECT to save the setting. You hear a
confirmation tone. Press
OFF/CANCEL to cancel.
NOTE: For more information on call screening, see pages 48-49.
Number of rings
²ÂÈ¶´ÁƸÇÇ»¸´ÁÆʸżÁºÆÌÆǸÀÇÂ´ÁÆʸÅ´Á¼Á¶ÂÀ¼Áº¶´¿¿´ì¸Å !ÂÅ
6 rings. You can also select toll saver, which is explained, as below. Unless you
¶»´Áº¸¼ÇÇ»¸´ÁÆʸżÁºÆÌÆǸÀ´ÁÆʸÅÆ´Á¼Á¶ÂÀ¼Áº¶´¿¿´ì¸Å¹ÂÈÅżÁºÆ
To set the number of rings:
1. When the handset is in idle mode, press MENU/
SELECT to
enter the main menu.
2. Press T
CID or SDIR to scroll to >Answering sys, then press
MENU/SELECT.
3. Press T
CID or SDIR to scroll to >Ans sys setup, then press
MENU/SELECT.
4. Press T
CID or SDIR to scroll to >
#
of rings, then press
MENU/SELECT.

Play messages
>Answering sys
Answer ON/OFF
>Ans sys setup
> Call screening
# of rings

CALL SCREENING
>On
Call screening
># of rings
# OF RINGS
>4