User's Manual

Getting started
9
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery, the
screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery. For
best performance, keep the handset in the telephone base or charger when
ÁÂÇ¼ÁÈƸ»¸µ´ÇǸÅÌ¼Æ¹È¿¿Ì¶»´Åº¸·´ì¸Å»ÂÈÅÆ¹¶ÂÁǼÁÈÂÈÆ¶»´Åº¼Áº
See the table on page 110 for battery operating times.
If the screen shows Place in charger and ë´Æ»¸Æ, you need to charge the
handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table
summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank, or shows
Place in charger and
ë´Æ»¼Áº
Battery has no or very little
charge. The handset cannot
be used.
Charge without interruption
(at least 30 minutes).
The screen shows Low
battery and
ë´Æ»¼Áº
Battery has enough charge
to be used for a short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
Step 1
Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label THIS SIDE
UP facing up, as indicated.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
THI
S
SIDE UP
/
C
E CÔTÉ VERS
L
E
HAUT
B
at
te
ry Pack / Bloc-pil
e
s
:
BT18
3
3
4
2/BT2
8
3342 (2.4V
4
00
mA
h
Ni-MH
)
W
ARNING
/
AV
E
R
TIS
S
E
M
E
NT :
DO
NOT BU
R
N OR
PUNCTURE BAT
T
ERIE
S
.
NE PAS INC
INÉ
R
E
R OU
P
E
RCER LES
P
IL
ES.
Ma
de
in Ch
ina
/
F
a
briqué en
ch
i
n
e
C
R15
3
5
THIS SIDE UP