User's Manual

Appendix
132
Troubleshooting
¢¹ÌÂÈ»´É¸·¼ï¶È¿ÇÌʼǻÌÂÈÅûÂÁ¸ÿ¸´Æ¸ÇÅÌÇ»¸¹Â¿¿ÂʼÁºÆÈºº¸ÆÇ¼ÂÁÆ
For Customer Service, visit our website at www.telephones.att.com or
call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
My telephone doesnt work at all.
f Make sure the power cord is securely plugged in.
f Make sure you plug the battery connector securely into the cordless handset.
f ¦´¾¸ÆÈŸÌÂÈÿȺÇ»¸Ǹ¿¸Ã»ÂÁ¸¿¼Á¸¶ÂÅ·Ƹ¶ÈŸ¿Ì´Á·èÅÀ¿Ì¼ÁÇÂÇ»¸
telephone base and the telephone wall jack.
f Charge the battery in the cordless handset for at least 10 hours. For
optimum daily performance, return the cordless handset to the charger
when not in use.
f If the battery is depleted, it may take approximately 30 minutes to charge
the handset before it shows Low battery. See page 10 for details.
f Reset the telephone base. Unplug the electrical power. Wait for
approximately 15 seconds, then plug it back in. Allow up to one minute for
the cordless handset and telephone base to reset.
f You may need to purchase a new battery. Please refer to
Battery installation and charging in this user’s manual on pages 10-11.
The display shows No line. I cannot get a dial tone.
f Try all the suggestions, as mentioned above.
f If the previous suggestions do not work, disconnect the telephone line
cord from your telephone and connect the telephone line cord to
another telephone.
f If there is no dial tone on that other telephone either, your telephone line
cord may be defective. Install a new telephone line cord.
f If changing the telephone line cord does not help, the wall jack (or
Ç»¸ʼżÁºÇÂÇ»¼ÆÊ´¿¿½´¶¾À´Ìµ¸·¸¹¸¶Ç¼É¸ÅÌÈÆ¼Áº´·¼æ¸Å¸ÁÇÊ´¿¿
jack in your home to connect your CL84107/CL84207/CL84257/CL84307/
CL84357 telephone, or contact your telephone service provider
(charges may apply).
I cannot dial out.
f Try all the suggestions, as mentioned above.
f Make sure you have a dial tone before dialing. The cordless handset may
Ç´¾¸´Ƹ¶ÂÁ·ÂÅÇÊÂÇÂèÁ·Ç»¸Ǹ¿¸Ã»ÂÁ¸µ´Æ¸´Á·ÃÅ·ȶ¸´·¼´¿ÇÂÁ¸
This is normal. Wait an extra second before dialing.