User's Manual

Multiple handset use

Push-to-talk (PTT)

Make an outgoing call during a PTT call

Using a handset or the telephone base:

During a one-to-one PTT call, press HOME/FLASH on your handset or

press HOME on the telephone base to get a dial tone. The PTT call

ends automatically.

During a one-to-group PTT call, press HOME/FLASH on the initiating

handset or press HOME on the telephone base. The PTT call ends

automatically and you get a dial tone.

During a one-to-group PTT call, press HOME/FLASH on any one of the

destination handsets or press HOME on the telephone base. That device

gets a dial tone. The PTT call continues for the rest of the PTT participants.

End or leave a PTT call

Using a handset or the telephone base:

For one-to-one PTT calls, both initiating and destination devices can end the

PTT call. For PTT calls to multiple devices, the initiating device can end the

PTT call. If any one of the destination devices leaves the PTT call, the call

continues until all participants or the initiator hangs up.

Press OFF/CLEAR or END on the handset, or press CANCEL or END on the

telephone base. The screen shows Push to talk Ended.

-OR-

Place the handset in the telephone base or charger, then the handset

return to idle mode.

NOTE: After PUSH TO TALK on the handset or PTT/FLASH on the telephone base is released,

the PTT call remains open for a short time. If no one presses PUSH TO TALK on the handset

or PTT/FLASH on the telephone base within ten seconds, the PTT call ends automatically.

•