User's Manual

Appendix

168

California Energy Commission battery charging testing instructions

This telephone is set up to comply with the energy-conserving standards right out of the box. These

instructions are intended for California Energy Commission (CEC) compliance testing only. When the

CEC battery charging testing mode is activated, all telephone functions, except battery charging,

will be disabled.

To activate the CEC battery charging testing mode:

1. Unplug the telephone base power adapter from the power outlet. Make sure all cordless handsets

are plugged with charged batteries and out of the chargers before proceeding.

2. While you press and hold /HANDSET LOCATOR, plug the telephone base power adapter back to

the power outlet.

3. After about 20 seconds, when the HOME light starts flashing, release

/HANDSET LOCATOR and

then press it again within two seconds. You hear a confirmation tone. The HOME light turns off and all

handsets display To register HS, see manual.. Allow up to one minute for the process to complete.

If the phone fails to enter this mode, repeat all the steps mentioned above. The telephone

base will be powered up as normal if you fail to press /HANDSET LOCATOR within two

seconds in Step 3.

To deactivate the CEC battery charging testing mode:

1. Unplug the telephone base power adapter from the power outlet, then plug it back in. The

telephone base is powered up as normal.

2. Register your handsets back to the telephone base. See pages 133-134 for handset

registration instructions.