User's Manual

Getting started
11
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery, the
screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery. For
best performance, keep the handset in the telephone base or charger when
not in use. The battery is fully charged after 11 hours of continuous charging.
See the table on page 171 for battery operating times.
If the screen shows Place in charger and flashes, you need to charge the
handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table
summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger
and
(flashing).
Battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and
(flashing).
Battery has enough charge
to be used for a short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base or
charger when not in use.
1. Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label
THIS SIDE UP facing up, as indicated.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
Battery
P
BT183342/
B
WARNING / A
DO NOT BURN
NE PA
S INCINÉ
Made i
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles
:
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING /
AV
ERTISSEMENT
:
DO NOT BURN OR PUN
CTURE BA
TTERIES.
NE P
AS INCINÉRER OU PERCER LES PILES.
Made in China / Fabri
qué en chine
CR1349