Instruction Manual

4
GETTING STARTED
The Singing Sounds Microphone is in try-me mode in the packaging.
To exit try-me mode, just slide the On/Off Switch from ON to OFF to
ON again.
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw. Then, remove the
cover.
3. If a depleted battery is present,
remove it by pulling up on one end of
the battery.
4. Install 3 new AAA (LR03/AM-4)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for
maximum performance).
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.