User's Manual
5
GETTING STARTED
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit and the remote control are turned OFF.
2. Locate the battery covers on the top of the unit and on the bottom
of the remote control. Use a screwdriver to loosen the screws.
3. First, install 6 new “AA” size (LR6/AM-3)
batteries following the diagram inside the
battery box in the main unit. Then, install
2 new “AA” size (LR6/AM-3) batteries
following the diagram inside the battery
box in the remote control. (The use of
new alkaline batteries is recommended for
maximum performance.)
4. Replace the covers of the battery
compartments (For the main unit, you will
needtopressdownrmlyonthecoverto
close it.), then tighten the screw.
Angus the RC T-Rex
Remote Control
Note: When the batteries run low, the toy will no longer respond. If this
happens, please replace the batteries.