User's Manual
6
assume no responsibility for any loss or claims by third parties that may 
arise through the use of this software. VTech
®
 Electronics North America, 
L.L.C. and its suppliers assume no responsibility for any damage or loss 
caused by deletion of data as a result of malfunction, dead battery, or 
repairs. Be sure to make backup copies of important data on other media 
to protect against data loss.
Company: VTech® Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200, Arlington Heights, IL 60004 USA
Phone : 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada
Note: This equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference by one or 
more of the following measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Connecttheequipmentintoanoutletonacircuitdifferentfromthat
to which the receiver is connected.
•Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
•Thebatteryisnotremovable.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES AND INDUSTRY 
CANADA LICENCE-EXEMPT RSS STANDARD(S). OPERATION IS 
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE 
MAY NOT CAUSE INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT 
ANY INTERFERENCE, INCLUDING INTERFERENCE THAT MAY CAUSE 
UNDESIRED OPERATION OF THE DEVICE. 
LE PRÉSENT APPAREIL EST CONFORME AUX CNR D'INDUSTRIE 
CANADA APPLICABLES AUX APPAREILS RADIO EXEMPTS DE LICENCE. 
L'EXPLOITATION EST AUTORISÉE AUX DEUX CONDITIONS SUIVANTES: 
(1) L'APPAREIL NE DOIT PAS PRODUIRE DE BROUILLAGE, ET (2) 
L'UTILISATEUR DE L'APPAREIL DOIT ACCEPTER TOUT BROUILLAGE 
RADIOÉLECTRIQUE SUBI, MÊME SI LE BROUILLAGE EST SUSCEPTIBLE 
D'EN COMPROMETTRE LE FONCTIONNEMENT.
Caution: Changes or modifications not expressly approved by the party 
responsible for compliance could void the user’s authority to operate 
the equipment.
A USB cable with a ferrite core must be used with this equipment to 
ensure compliance with the Class B FCC limits.
91-003339-006(H1).indd 6 2017/6/16 14:06:29










