User's Manual

Stylus Fastener Use the stylus string to attach the stylus to this

fastener.

Slide these switches to open the battery doors.

Always replace the InnoTab

3S battery doors

after changing batteries.

microSD Memory Card Slot Insert a microSD memory card (not included).

(NOTE: InnoTab

3S is compatible with

microSD memory cards up to 32GB.)

Battery Compartments Insert 4 "AA" batteries or the rechargeable

batte ry packs. Fo r ba tter y insta llat ion

instructions, please see the section below.

Installing the Rechargeable Battery Packs

1. Make sure the InnoTab® 3 or InnoTab® 3S is turned off.

2. Turn the unit over. Slide the battery door lock switch (or switches) forward

and push the battery covers off to each side to remove them.

3. Remove any old batteries that may be in the toy. (Battery removal and

replacement should be done by an adult.)

4. Insert Battery Pack① into the compartment on the right side and Battery

Pack② into the compartment on the left side.

 •Insertthebatterypackintotheconnectorslotfirst.

 •Thenpressthebatterypackdownuntilitrestsinplace.

5. Replacethebatterycovers.

Charging and Recharging the Batteries

The rechargeable batteries should be fully charged before the first use. To charge

and recharge the batteries, please follow the instructions below.

1. Make sure the battery packs are installed in the tablet.

2. Plug one end of the AC adapter into the power jack on the InnoTab

and plug

the other end into a wall outlet.

Battery Door Lock Sliding

Switches