User Manual

26
The cartridge icon does
not appear on desktop
Poor cartridge
connection
Remove the cartridge, clean it if
necessary, and then re-insert it
into the InnoTab
®
2S.
The cartridge is not
compatible.
Check the cartridge label or
cartridge user's manual to
make sure it is compatible to
InnoTab
®
2S.
USB connection window
does not pop up after
connecting to computer
Poor USB cable
connection
Securely connect the USB
cable to InnoTab
®
2S and the
computer.
Connection is
running through
USB hub
Connect the InnoTab
®
2S
directly to the computer, without
using a hub.
Clock time is not
accurate
Backup battery
power low
Replace backup battery (for
backup battery replacement
instructions, please see the
Care & Maintenance section on
page 23).
Touch screen is
inaccurate or it is
impossible to select
the correct icon on the
screen.
Touch screen
requires calibration.
Turn the InnoTab
®
2S OFF. Then
hold
, and down
when turning the InnoTab
®
2SON.
Follow the steps on the screen.
Inserted an SD memory
card (not included),
but the tablet cannot
recognize it.
SD memory card
format is not FAT32.
Format the SD memory card to
FAT32 in your computer.
Files copied to the
tablet's internal memory
disappeared.
The tablet's memory
was not formatted to
FAT32.
If formatting the memory is
necessary, make sure it is
formatted to FAT32.
Cannot connect to Wi-Fi. The Wi-Fi is
disabled.
Press
to enable Wi-Fi.
Wi-Fi is enabled,
but there is no Wi-Fi
network available.
There is no Wi-Fi
network in your
location or network
signal is weak.
Move to a location that has an
available Wi-Fi network.
T
R
O
U
B
L
E
S
H
O
O
T
I
N
G