User's Manual

GETTING STARTED

BATTERY INSTALLATION

1. Make sure the unit and remote control are turned OFF.

2. Locate the battery cover on the bottom of the unit and remote control.

Use a screwdriver to loosen the screw.

3. First, install 6 new “AA” size (LR6/AM-3) batteries following the

diagram inside the battery box in the main unit. Then, install 2 new

“AA” size (LR6/AM-3) batteries following the diagram inside the

battery box in the remote controller. (The use of new alkaline batteries

is recommended for maximum performance.)

4. Replace the battery cover and tighten the screw in both to secure it.

NOTE: When the battery runs low, the toy will no longer respond. If this

happens, please replace the battery.

Getting Started

Bronco the RC Triceratops™ Remote Control