Specifications

36 Chapter 2: Hardware installation

• External auxiliary I/O connector 1 (DB-9). Used to receive opto-isolated trigger

input signals.

You can use the Matrox DVI-TO-8BNC/O input cable to connect to your video

sources. The cable has a DVI connector on one end and both 8 BNCs and

open-ended wires on the other end; the open-ended wires allow you to connect

to some timing, synchronization, and control signals of the frame grabber. Two

of these cables are required to connect to more than 4 video sources if using Matrox

Solios eA/XA Quad, more than 2 video sources if using Matrox Solios eA/XA

Dual, or more than one video source if using Matrox Solios eA/XA Single.

Connector #1

Connector #0

Connector #1

Analog

Video Input

External

Auxiliary I/O